First of all you will need to strip the old carpet from the stairs.
Carpet around stairs balusters.
How to carpet stairs.
Fitting flooring around stair rail spindles we are getting some hardwood flooring installed in parts of the house we are moving to.
Http www directcarpet ca how to carpet stairs through rails spindles with keith shannon direct carpet 905 575 7847 here is a techni.
Find a good place to start removing carpet from stairs.
Each piece of carpet was also wrapped around the edges of the stairs and around the balusters so i had to remove the staples holding it in.
Installing a carpet around balusters.
And here s the diy handrail in place.
Occasionally during a remodel or even in new construction stair treads are carpeted before the stair rail is installed.
Next we d pre drill a hole into the stair and then we would basically screw the baluster into place until it was flush against the floor.
Installing a carpet on a staircase is a challenging job and needs to be done carefully otherwise you risk deteriorating the carpet and waste money.
After a hole was drilled into the baluster we d put a two sided screw halfway into it.
A flooring company quoted an extra 700 to have the stair railing removed and re installed after the flooring installation was complete and over a hundred dollars for bull nose trim material.
Carpeting a staircase also may be.
When it comes time to replace it you will need to know how to properly carpet around the staircase balusters.
However over time this carpet will eventually wear out because of the foot traffic.
I started at the bottom corner of the stairs by using a crowbar to pry the carpet away from the tack strip.
Tips for removing carpet from stairs.
Installing a carpet on a staircase is a challenging job and needs to be done carefully otherwise you risk deteriorating the carpet and waste money.
The parts that are difficult to cover are the areas around the balusters.
Well you could put it in around the spindles but will have to make some very precise cuts.
You could notch the pieces around the spindle and make sure the joint between two boards are somewhere between the edges of the spindle for easier cutting.
Here s how you can do it.
First of all you will need to strip the old carpet from.
Step 1 stripping.
Here s a close up look at putting a baluster into place.
You would need to be very careful in the cut so it is a very tight fit.
You will find that carpet can make a nice cushion whenever you add them to stairs.
The parts that are difficult to cover are the areas around the balusters.